Electrical Requirements
This snippet causes dropdowns to open on page load. This text/paragraph does not appear in the output.
The line voltage of the iScan is 100–240 VAC operating at either 50 Hz or 60 Hz. The system consumes a maximum of 300 Watts.
The voltage of the AutoLoader 2.x is 100–240 VAC, 110 VA operating at 47-63 Hz.
Power Specifications
|
Specification |
Instrument |
AutoLoader 2.x |
|---|---|---|
|
Line Voltage |
100–240 VAC, 50 Hz or 60 Hz |
100–240 VAC at 47–63 Hz |
|
Power |
Maximum 300 Watts |
110 VA (Maximum 110 Watts) |
Receptacles
Your facility must be wired with the following equipment.
| • | For 100–120 Volts AC—A 20 amp grounded dedicated line with proper voltage and electrical ground is required. |
North America and Japan—Receptacle: NEMA 5-20
Interpower Corp. Receptacle, part # 88030080 (or equivalent).
| • | For 200–240 Volts AC—At minimum, 10 amp grounded line with proper voltage and electrical ground is required. Use a higher rating as needed according to requirements for your region. |
| • | If the voltage fluctuates more than 10%, a power line regulator is required. |
Power Cords
The instrument is equipped with an international standard IEC 60320 C13 receptacle and is shipped with a region-specific power cord.
Hazardous voltages are removed from the instrument only when the power cord is disconnected from the AC power source.
To obtain equivalent receptacles or power cords that comply with local standards, consult a third-party supplier such as Interpower Corporation (www.interpower.com).
Never use an extension cord to connect the instrument to a power supply.
Protective Earth
|
|
The instrument has a connection to protective earth through the enclosure. The safety ground on the power cord returns protective earth to a safe reference. The protective earth connection on the power cord must be in good working condition when using this device. |
Uninterruptible Power Supply
The iScan System is shipped with a region-specific uninterruptible power supply (UPS). Illumina is not responsible for runs affected by interrupted power regardless of whether the instrument is connected to a UPS. Standard generator-backed power is often not uninterruptible and a brief power outage occurs before power resumes.
The UPS may be hot. Handle with caution.
The following table shows information
|
Specification |
North America |
|
Japan |
|---|---|---|---|
|
Max Watts |
560 Watts |
560 Watts |
560 Watts |
|
VA Rating |
800 VA |
800 VA |
660 VA |
|
Input Voltage (Nominal) |
120 VAC (96–151 VAC without using batteries) |
230 VAC (181–290 VAC without using batteries) |
100 VAC 60 Hz |
|
Input Connection |
NEMA 5-15P |
IEC 320 Inlet Module with input line cord provided |
NEMA 5-15P |
* Backup run time information is based on estimates. Actual run time can vary, depending on the loads and power factors of the protected equipment and the condition of the UPS batteries.
Fuses
Only Illumina field personnel are qualified to replace internal fuses. The power entry module includes two input fuses on the high-voltage input lines.
iScan fuses: The fuses are size 5 x 20 mm and rated for 10 amps, 250 VAC, Slo-Blo.
AutoLoader 2.x fuses: The fuses are size 2 x 5 mm and rated for 2 amps, 250 VAC, T Class.
