Power Cycle the Instrument
Use the following procedure to power cycle the instrument after a software update or for troubleshooting.
|
1.
|
From the Main Menu, select Shut Down Instrument. When prompted to exit the control software, select Yes. |
|
2.
|
After the instrument computer has shut down, switch the toggle power switch at the back of the instrument to the O (Off) position. |
Refer to Figure 6 for the power switch location.
|
3.
|
Wait a minimum of 60 seconds. |
|
4.
|
Switch the toggle power switch on the back of the instrument to the | (On) position. |
The instrument computer will boot automatically.
|
5.
|
Wait for the system to load, and then log on to the operating system. |