Product Compliance and Regulatory Statements

The Illumina iSeq 100 Sequencing System complies with the following statements and certifications.

The iSeq 100 is compliant with the following directives:

• EMC 2014/30/EU
• Low Voltage 2014/35/EU
• Radio Equipment 2014/53/EU

The complete EU declarations of conformity and certificates of compliance are available on the Illumina website at support.illumina.com/certificates.html.

This equipment complies with maximum permissible exposure (MPE) limits for the general population per Title 47 CFR § 1.1310 Table 1.

This equipment complies with the limitation of human exposure to electromagnetic fields (EMFs) for devices operating within the frequency range 0 Hz to 10 GHz, used in radio frequency identification (RFID) and transmitters operating in 2.4 GHz and 5 GHz frequencies, in an occupational or professional environment. (EN 50364:2010 sections 4.0; EN 62311:2008; EN 62479:2010).

This equipment should be installed and operated with minimum distance 20 cm (8 in) between the radiator and your body.

For information on RFID compliance, refer to the RFID Reader Compliance Guide (1000000002699) at support.illumina.com/downloads/rfid-reader-compliance-guide-1000000002699.html.

The device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency range.

The frequency, mode, and the maximum transmitted power in EU are listed below:

• 2412–2472 MHz (802.11g6Mbps): 19.98 dBm
• 2402–2480 MHz (EDR 3Mbps): 9.65 dBm
• 2402–2480 MHz (LE 1Mbps): 9.80 dBm
• 5180–5240/ 5260–5320/5500–5700 MHz (802.11acVHT40 MCS0/NSS1): 22.95 dBm

Conformidade ANATEL: Este equipamento foi testado e está em conformidade com as resoluções da ANATEL 442, 242 e 506.

Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter primário.

This Class A digital apparatus meets all requirements of the Canadian Interference‐Causing Equipment Regulations.

This device complies with Industry Canada license‐exempt RSS standards. Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Conformidad con Instituto Federal de Telecomunicaciones

La operación de este equipo está sujeta a las siguientes dos condiciones:

1. Es posible que este equipo o dispositivo no cause interferencia perjudicial.
2. Este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada.

IFETEL No.: RCPILEX 13-2029

IFETEL No.: RCPRERT16-1591

해당 무선 설비는 운용 중 전파 혼신 가능성이 있음.

A급 기기(업무용 방송통신기자재)

이 기기는 업무용(A급) 전자파적합기기로서 판매자 또는 사용자는 이 점을

주의하시기 바라며, 가정 외의 지역에서 사용하는 것을 목적으로 합니다.

低功率電波輻性電機管理辦法

第十二條經型式認證合格之低功率射頻電機，非經許可，公司、商號或使 用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。

第十四條低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發 現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。

前項合法通信，指依電信規定作業之無線電信。

低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

在5.25G ~5.35G頻帶內操作之無線資訊傳輸設備僅適於室內使用

This telecommunication equipment conforms to the requirements of the National Telecommunications Commission.

This equipment has been designed and tested to the CISPR 11 Class A standard. In a domestic environment, it might cause radio interference. If radio interference occurs, you might need to mitigate it.

Do not use the device in close proximity to sources of strong electromagnetic radiation, which can interfere with proper operation.

Evaluate the electromagnetic environment before operating the device.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instrumentation manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case users will be required to correct the interference at their own expense.